Question Set

1. Plasticisers are high boiling liquids added to plastic polymers to impart toughness and flexibility at ordinary temperature. Which of the following is not a plasticiser ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The hard; plastic covers of telephones are made of polymers?....
QA->On a cold day when a room temperature is 15oC, the metallic cap of a pen becomes much colder than its plastic body, though both are at the same temperature of 15oC, because?....
QA->Blisters are formed more rapidly by the steam of boiling water in comparision to boiling water itself because ________.?....
QA->Which type of soil is developed in areas with high temperature & high rainfall?....
QA->Which was the first school established by the government to impart English education in Travancore?....
MCQ->Plasticisers are high boiling liquids added to plastic polymers to impart toughness and flexibility at ordinary temperature. Which of the following is not a plasticiser ?....
MCQ->For stable structures, one of the important properties of flexibility and stiffness matrices is that the elements on the main diagonal i) of a stiffness matrix must be positive ii) of a stiffness matrix must be negative iii) of a flexibility matrix must be positive iv) of a flexibility matrix must be negative The correct answer is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Plasticisers are added to polymers to improve their....
MCQ->S1: Metals are today being replaced by polymers in many applications. P : Above all, they are cheaper and easier to process making them a viable alternative to metals. Q : Polymers are essentially a long chains of hydrocarbon molecules. R : Today polymers as strong as metals have been developed. S : These have replaced the traditional chromium-plated metallic bumpers in cars. S6: Many Indian Institutes of science and Technology run special programmes on polymer science. The Proper sequence should be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution