Question Set

1. To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a number is increased by 30% and then from the increased number its 30% is decreased. Then :....
QA->If the diameter of a circle is increased by 100%, its area is increased by :....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->An​ ​electrochemical​ ​cell​ ​which​ ​is​ ​used​ ​as​ ​a​ ​source​ ​of​ ​direct​ ​electrical current​ ​at​ constant​ ​voltage​ ​under​ ​standard​ ​conditions​ ​is​ ​called​ ​a:....
MCQ->To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of....
MCQ->At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied: Po = ρ/ρN3 D5 : Power number Re = ρ N D2/μ: Reynold's number N is the impeller rotational speed, and D is the impeller diameter.....
MCQ->The power number for a stirred tank becomes constant at high Reynolds number. In this limit, the variation of power input with impeller rotational speed (N) is proportional to....
MCQ->The following statements relate to a laminar flow : 1. Laminar flow is rotational. 2. In laminar flow the loss of head is proportional to the square of the velocity. 3. In laminar flow the loss of head is proportional to the first power of viscosity. 4. In laminar flow the velocity is constant over the cross-section. 5. Other quantities remaining the same, increase in diameter will increase the Reynolds number in laminar flow. Of these statements :....
MCQ->For turbulent flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei, is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution