Question Set

1. In shell and tube heat exchangers, straight tie rods are used to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->In which mode of transmission, the heat waves travel along the straight line with the speed of light?....
MCQ->In shell and tube heat exchangers, straight tie rods are used to....
MCQ->Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is....
MCQ->Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat. Heat transfer co-efficient for the cooling water, whether on shell side or tube side is the same. The best arrangement is....
MCQ->Consider the following statements about provision of sag rods : 1. Sag rods reduce span length of purlin in the weak direction. 2. Sag rods are installed in the plane of the roof. 3. Ridge purlin is subject to vertical components of sag rods on either side of slope. Which of the statements given above are correct ?....
MCQ->In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution