Question Set

1. For high pressure process equipments/vessels, the connected nozzle should be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which winds are flowing from sub tropical high pressure to sub polar low pressure?....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->What is the voltage at which house hold Ac (Alternating Current) equipments work?....
QA->Blood pressure is the pressure exerted on the wall of which part?....
QA->A small weight is put on the pressure cooker. It increases the pressure of the steam. Why?....
MCQ->For high pressure process equipments/vessels, the connected nozzle should be....
MCQ->The velocity of steam leaving the nozzle (V) is given by (where K = Nozzle coefficient or nozzle efficiency, and hd = Enthalpy or heat drop during expansion of steam in a nozzle)....
MCQ->When the back pressure of a nozzle is below the designed value of pressure at exit of nozzle, the nozzle is said to be....
MCQ->A nozzle is fitted at the end of a pipe whose length is 320 m and diameter is 10 cm. If the value of f = 0.01, the diameter of the nozzle for the maximum transmission of power through the nozzle is....
MCQ->A nozzle is said to be a convergent-divergent nozzle, when the cross-section of a nozzle first decreases from its entrance to throat and then increases from its throat to exit.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution