Question Set

1. If the depth of moist sand in a cylinder is 15 cm and the depth of the sand when fully inundated with water is 12 cm, the bulking of the moist sand, is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is known in the names of ‘Singing sand, Whistling sand and Barking sand’ ?....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The ratio between the radius of the base and the height of a cylinder is 2 : If its volume is 1617 cm3, the total surface area of the cylinder is—....
QA->Cement mixed with gravel; sand and water is called?....
QA->Which of the following is used for lifting water from 8-10 m depth ?....
MCQ->If the depth of moist sand in a cylinder is 15 cm and the depth of the sand when fully inundated with water is 12 cm, the bulking of the moist sand, is....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->Consider the following statements regarding the phenomenon of bulking of sand : 1. It is due to film of water around sand particles. 2. It is due to capillary action. 3. It is more in finer sands. Which of the following statements given above is/are correct ?....
MCQ->A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, The junction radius is 60 mm and the junction pressure is 1.1 N/mm2. The maximum hoop stress developed in the inner cylinder is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution