1. In a compaction test, as the compaction effort is increased, the optimum moisture content





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which compound does not give a positive test in Lassaigne’s test for nitrogen?....
QA->Which compound gives both ninhydrin test and Molisch’s test?....
QA->Which surface to air missile was successfully test fired from Interim Test Range (ITR), Chandipur, Odhisa by Defence Research and Development Organisation (DRDO)?....
QA->Plants that grow in a dry habitat like deserts and can survive without moisture?....
QA->Global Polio Eradication Programme is a Joint effort led by WHO; UNICEF and ?....
MCQ->In a compaction test, as the compaction effort is increased, the optimum moisture content....
MCQ->It takes 6 hours to dry a wet solid from 50% moisture content to the critical moisture content of 15%. How much longer it will take to dry the solid to 10% moisture content, under the same drying conditions? (The equilibrium moisture content of the solid is 5%).....
MCQ->A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))....
MCQ->In a compaction test on a soil sample, if the compaction energy is decreased (γd = maximum dry density, OMC = optimum moisture content)....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions