1. All the ecosystem taken together in a geographical area form a bigger unit called?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->Which state is the percentage of forest area to total geographical area the highest?....
QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....
QA->Which ecosystem covers the largest area of the earth’s surface?....
QA->Which country has the world’s highest percentage of arable land to the total geographical area?....
MCQ->All the ecosystem taken together in a geographical area form a bigger unit called?....
MCQ->In order to comply with TRIPS Agreement, India enacted the Geographical Indications of Goods (Registration Protection) Act, 1999. The difference/differences between a "Trade Mark" and a Geographical Indication is/are: 1. A Trade Mark is an individual or a company's right whereas a Geographical Indication is a community's right. 2. A Trade Mark can be licensed whereas a Geographical Indication cannot be licensed. 3. A Trade Mark is assigned to the manufactured goods whereas the Geographical Indication is assigned to the agricultural goods/products and handicrafts only. Which of the statements given above is/are correct ?....
MCQ->Spot is bigger than King and smaller than Sugar. Ralph is smaller than Sugar and bigger than Spot. King is bigger than Ralph. If the first two statements are true, the third statement is....
MCQ->The area of a plot is to be determined using Simpson's rule. The following offsets were taken to a boundary from points along a chain line all measurements being in metres 12, 15, 22, 29, 36, 38, 31, 22, 17.There were taken at 100 m intervals. Consider the following steps in this regard. 1. 2. Sum of the odd ordinates = 22 + 36 + 1 = 89 3. Sum of the even ordinates = 15 + 29 + 38 + 22 = 104 4. 12 + 17 = 39 5. Area = 100 (19.5 + 89 + 104) 6. Area = (39 + 2 x 89 + 4 x 104) 7. Area 100 x 19.5 (104 - 89) The area of the plot can be determined by using the steps listed above :....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution