Question Set

1. For a comfortable travel on Highways, the centrifugal ratio should not exceed






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->At his usual rowing rate, Ram can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
MCQ->For a comfortable travel on Highways, the centrifugal ratio should not exceed....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
MCQ->Rivets and bolts subjected to both shear stress (τvf , cal) and axial tensile stress (σtf , cal) shall be so proportioned that the stresses do not exceed the respective allowable stresses τvf and σtf and the value of exceed does not exceed....
MCQ->Road width 8.8 m of two lane National highways or State highways in mountainous terrain....
MCQ->Roadway width for a National highways and State highways (two-lanes) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution