Question Set

1. On a flow net diagram, the distance between two consecutive steam lines at two successive sections are 1 cm and 0.5 cm respectively. If the velocity at the first section is 1 m/sec, the velocity at the second is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is the distance between two consecutive longitudes (910 E and 920 E) at-the Poles?....
QA->The distance between two successive crests or troughs is?....
QA->There are 3 numbers .The product of the first and the second is The product of second and the third is The product of the first and the third is Find the numbers....
QA->A major belt of asteroids is located between Mars and Jupiter. What is the approximate average distance between the Sun and this major asteroid belt?....
QA->The interval between two consecutive sessions of Lok Sabha shall be less than ........ months?....
MCQ->On a flow net diagram, the distance between two consecutive steam lines at two successive sections are 1 cm and 0.5 cm respectively. If the velocity at the first section is 1 m/sec, the velocity at the second is....
MCQ->A beam of rectangular section 100 mm x 300 mm carries certain loads such that the Bending Moment at a section A is M ans at another section B it is (M + C).The distance between the sections A and B is 0.5 m and there are no external loads acting between the two sections. If the value of C is 10, 000 Nm, then the maximum shear stress is....
MCQ->The following statements relate to a laminar flow : 1. Laminar flow is rotational. 2. In laminar flow the loss of head is proportional to the square of the velocity. 3. In laminar flow the loss of head is proportional to the first power of viscosity. 4. In laminar flow the velocity is constant over the cross-section. 5. Other quantities remaining the same, increase in diameter will increase the Reynolds number in laminar flow. Of these statements :....
MCQ->Which of the following is not a dimension-less group used in catalysis ? (where, D = dispersion co-efficient, cm2 /sec.D1 = diffusion co-efficient; cm2/sec L = length of the reactor, cm t = time, sec, v = volumetric flow rate, cm3/sec . V = volume, cm3.)....
MCQ->A linear relationship is observed between speed and density on a certain section of a highway. The free flow speed is observed to be 80 km per hour and the jam density is estimated as 100 vehicles per km length. Based on the above relationship, the maximum flow expected on this section and the speed at the maximum flow will respectively be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution