Question Set

1. A beam of rectangular section 100 mm x 300 mm carries certain loads such that the Bending Moment at a section A is M ans at another section B it is (M + C).The distance between the sections A and B is 0.5 m and there are no external loads acting between the two sections. If the value of C is 10, 000 Nm, then the maximum shear stress is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Sound produced at a point is heard by a person after 5 second, while the same sound is heard by another person after 6 seconds. If the speed of sound is 300 m/s, what could be the maximum and minimum distances between the two persons?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->In a road map the scale is 1 cm = 8 km. If there are two places of cm apart is marked in that map. Then the actual distance between that places is :....
QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....
QA->. Nasar invested Rs. 3,000 and Narayanan invested Rs. 4,000 to set up a partnership. In one year they got Rs.2,000 profit. If they split this in the ratio of their investment., how much would Nasar got?....
MCQ->A beam of rectangular section 100 mm x 300 mm carries certain loads such that the Bending Moment at a section A is M ans at another section B it is (M + C).The distance between the sections A and B is 0.5 m and there are no external loads acting between the two sections. If the value of C is 10, 000 Nm, then the maximum shear stress is....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
MCQ->A simply supported beam of uniform cross-section is subjected to a maximum bending moment of 2.25 t.m. If it has rectangular cross-section with width 15 cm and depth 30 cm, then the maximum bending stress induced in the beam will be....
MCQ->A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to....
MCQ->Closing capitals of A,B and C were Rs.50,000,Rs.45,000 and Rs.30,000 respectively.Their drawings during the year were Rs.10,000,Rs.5,000 and Rs.12,000 respectively.Amount of net profit earned during the year was Rs.18,000 which was distributed in the ratio of 3:2:1 Opening capital of C will be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution