For mountaneous regions having steep slope, wagons for carrying liquid are made with bottom ?->(Show Answer!)

Question Set

1. For mountaneous regions having steep slope, wagons for carrying liquid are made with bottom

Show Similar Question And Answers

QA->The pressure at the bottom of a liquid tank does not depend on which area?....

QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....

QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....

QA->Which cold and dense air blowing down the mountain slope during the night?....

QA->The electricity carrying cables buried underground made of?....

MCQ->For mountaneous regions having steep slope, wagons for carrying liquid are made with bottom....

MCQ->1000 Kg of liquid at 30°C in a well stirred vessel has to be heated to 120°C, using immersed coils carrying condensing steam at 150°C. The area of the steam coils is 1.2 m2 and the overall heat transfer co-efficient to the liquid is 1500 W/m2.°C. Assuming negligible heat loss to the surrounding and specific heat capacity of the liquid to be 4 kJ/kg.°C, the time taken for the liquid to reach desired temperature will be....

MCQ->Statement: 'Move into the upper echelons without paying a steep price - Book a luxurious flat with us'. An advertisement of a construction company for its prestigious project. Assumptions: It is possible to join the select band of rich people by hard work. Staying in luxury without paying steep price is the criterion of upper crust of the society. Booking a luxurious flat is very easy now.

MCQ->Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution