Question Set

1. If D is the depth of water upstream of the throat above its sill, B is the width of the throat, to achieve critical flow in an open venturi flume, the theoretical maximum flow Q, is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The length of a rectangular floor is 2 meters more than its width and its perimeter is 20 meters, then its area is....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is:....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is....
QA->A boat goes 30 km upstream and 44 km downstream in 10 hrs. In 13 hrs, it can go 40 km upstream and 55 km downstream. The speed of the boat in still water is....
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
MCQ->If D is the depth of water upstream of the throat above its sill, B is the width of the throat, to achieve critical flow in an open venturi flume, the theoretical maximum flow Q, is....
MCQ->Consider the following factors : 1. Provision of a suitable slope to the top of the sill. 2. Proper throating of the sill to throw off the water outside. 3. Giving a projection of not less than 50 mm to the sill. 4. Providing damp-proof course below the sill to check the entry of moisture inside the main wall. Those considered while constructing a brick sill would include....
MCQ->In a 4 m wide rectangular channel with 0.8 m depth of flow, a sharp-crested weir of 2.5 m length with its sill 0.3 m above the channel bed is fixed symmetrically across the width of the channel. Taking the flow to be free but with end contractions, what would be the discharge neglecting approach velocity effect? (Take Cd = 0.625)....
MCQ->For flow under a sluice gate where the upstream depth is 1.2 m and the depth at vena contracta is 0.3 m, the discharge per meter width would be nearly....
MCQ->In the case of S2 water surface profile (y = depth of flow, y0 = normal depth, yc = critical depth)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution