Question Set

1. In case of cantilever fillers, the ratio of the span L to depth d, should not exceed






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
QA->In a mixture of 35 litres, the ratio of milk and water is 5 : Another 5 litres of milk is added to the mixture. The ratio of milk and water in the new mixture is—....
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
MCQ->What will be the output of the C#.NET code snippet given below? char ch = Convert.ToChar ('a' | 'b' | 'c'); switch (ch) { case 'A': case 'a': Console.WriteLine ("case A | case a"); break; case 'B': case 'b': Console.WriteLine ("case B | case b"); break; case 'C': case 'c': case 'D': case 'd': Console.WriteLine ("case D | case d"); break; }....
MCQ->In case of cantilever fillers, the ratio of the span L to depth d, should not exceed....
MCQ->Spans of continuous fillers are considered approximately equal if the longest span does not exceed the shortest span by more than....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
MCQ->A simply supported beam of span L carries a concentrated load W at its mid-span. If the width 'b' of the beam is constant throughout the span, then, when the permissible bending stress is 'f', the beam's mid-span depth will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution