Question Set

1. The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Read the statements carefully and answer the question which follow: A cube has six sides each of a different colour.The red side is opposite black.The green side is between red and black.The blue side is adjacent to white .The brown side is adjacent to blue.The red side is face down.The side opposite brown is:....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Who said ‘Climbing to the top demands strength; whether it is to the top of Mount Everest or to the top of your career’?....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
MCQ->The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed....
MCQ->The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
MCQ->A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm2. If the slope at the ends is 0.005 radian and the value of E = 0.2 x 106 N/mm2, the depth of the joist, is....
MCQ->Consider the following library functions
  1. EXP (i.e., ex)
  2. ARCTAN (i.e. tan-1 x)
  3. SQRT (i.e., x)
  4. AES (i.e. |x|)

Which of the above are allowed in Pascal?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution