Question Set

1. Stiffeners are used in a plate girder





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->എന്താണ് ഫലകചലനം സിദ്ധാന്തം (Plate Tectonics) ? ....
QA->The Terisapalli Copper Plate of 849 AD was issued by Ayyan Atikal Tirivatikal for which Kulasekhara ruler?....
QA->TheJewish Copper plate of 1000AD(175 Kollam Era) was issued by ?....
QA->PaJiyam Copper Plate (925 AD) of Vikramaditya Varaguna mentions about ?....
QA->Earliest available inscription dated in the Kollam Era; the Mampalli Plate (149) is ascribed to?....
MCQ->Consider the following statements pertaining to intermediate stiffeners : 1. Stiffeners are provided to exclusively bear concentrated loads. 2. Stiffeners should bear tightly against top and bottom flanges. 3. Maximum spacing of stiffeners is restricted 180 t, where t is the thickness of web. Which of the statements given above is are/correct ?....
MCQ->When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is....
MCQ->Gross flange area for a riveted plate girder is to be designed considering net area as 80% of its gross area. Consider width of the flange as 500 mm while web plate as 1000 mm x 12 mm. The girder is to resist a maxi-mum BM of 4500 kNm. Maximum allowable bending stress in tension is 150 MPa. Gross flange area is....
MCQ->In case horizontal stiffeners are not used, the distance between vertical legs of flange angles at the top and bottom of a plate girder, is known as....
MCQ->Stiffeners are used in a plate girder....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution