Question Set

1. In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the grossdiameter of the rivet is 26 mm, the number of rivets required in the splice, is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is....
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is:....
QA->A number consists of two digits.The digits in the ten’s place is 2 times of the digit in the unit’s place.If 36 is substracted from the number,the digits are reversed.The number is....
QA->Use of mild words in place of words required by truth.....
QA->Longest Steel Arch Bridge?....
MCQ->In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the grossdiameter of the rivet is 26 mm, the number of rivets required in the splice, is....
MCQ->A mild steel flat subjected to a tensile force of 84 tonnes is connected to a gusset plate using rivets. If the forces required to shear a single rivet, to crush the rivet and to tear the plate per pitch length are 5000 kg, 8000 kg and 6000 kg respectively, then the number of rivets required is....
MCQ->A structural member carrying a pull of 700 kN is connected to a gusset plate using rivets. If the pulls required to shear the rivet, to crush the rivet and to tear the plate per pitch length are respectively 60 kN, 35 kN and 70 kN, then the number of rivets required will be....
MCQ->If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is....
MCQ->Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution