Question Set

1. The reinforcing bars in beams are not bundled in contact if the diameter of the bars, exceeds






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->A liquid will not wet the surface of solid if the angle of contact is?....
QA->“Ask not, Say not, think not caste” are the words of?....
QA->“ Liquor is poison, make it not, sell it not, drink it not” are the words of?....
QA->Liquor is poison, make it not, sell it not, drink it not are the words of:....
MCQ->The reinforcing bars in beams are not bundled in contact if the diameter of the bars, exceeds....
MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....
MCQ->Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is....
MCQ->The development length of each bar of three bars bundled together is increased by....
MCQ->A square column section of size 350 mm is 350 mm is reinforced with four bars of 25 mm diameter and four bars of 16 mm diameter. Then the transverse steel should be :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution