Question Set

1. The angle of inclination of the lacing bars with axis of the member is kept between





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is a graph is plotted taking °C along the Y-axis and of K along the X-axis?....
QA->If a graph is plotted taking the temperature in Fahrenheit along the Y-axis and the corresponding temperature in Celsius along X- axis it will be the straight line?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
MCQ->The angle of inclination of the lacing bars with axis of the member is kept between....
MCQ->The following observation relate to designing of laced column : 1. Single lacing systems on opposite planes shall preferably be in the same direction so that one is the shadow of the other. 2. Lacing bar should only be a flat. 3. The slenderness ratio of the lacing bars for compression shall not exceed 180. 4. Laced compression members are to be provided with tie plates of ends. Of these observations :....
MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....
MCQ->According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)....
MCQ->The width of lacing bars in mm is kept....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution