Question Set

1. A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which radiation carries maximum energy?....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
QA->With whose assistance was Bokaro Steel Limited established?....
QA->Which General Insurance Company will be merged with National Insurance Company Limited and United India Assurance Company Limited to create a single insurance entity?....
MCQ->A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is....
MCQ->A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm2. If the slope at the ends is 0.005 radian and the value of E = 0.2 x 106 N/mm2, the depth of the joist, is....
MCQ->A simply supported beam of span L carries a concentrated load W at its mid-span. If the width 'b' of the beam is constant throughout the span, then, when the permissible bending stress is 'f', the beam's mid-span depth will be....
MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....
MCQ->A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm2 and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution