1. A locomotive has four pairs of driving wheels carrying an axle load of 24 x 104 N. The maximum load that can be pulled if the coefficient of friction is 1/6, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Wheels within wheels....
QA->Find the maximum velocity for the overturn of a car moving on a circular track of radius 100 m. The co-efficient of friction between the road and tyre is 0.2?....
QA->A word is given in capital letters. It is followed by four words. Out of these four words, three cannot be formed from the letters of the word in capital letters. Point out the word which can be formed from the letters of the given word in capital letters— ARCHITECTURE....
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->The Supreme Court has recently pulled up which government to an act which allows construction in Aravalli hills?....
MCQ->A locomotive has four pairs of driving wheels carrying an axle load of 24 x 104 N. The maximum load that can be pulled if the coefficient of friction is 1/6, is....
MCQ->A train is hauled by 2-8-2 locomotive with 22.5 tonnes load on each driving axle. Assuming the coefficient of rail-wheel friction to be 0.25, what would be the hauling capacity of the locomotive ?....
MCQ->The sports car has a mass of 1.5 Mg and a center of mass at G. Determine the shortest time it takes for it to reach a speed of 80 km/h, starting from rest, if the engine only drives the rear wheels, whereas the front wheels are free rolling. The coefficient of friction between the wheels and road is = 0.2. Neglect the mass of the wheels for the calculation.....
MCQ->The area of a plot is to be determined using Simpson's rule. The following offsets were taken to a boundary from points along a chain line all measurements being in metres 12, 15, 22, 29, 36, 38, 31, 22, 17.There were taken at 100 m intervals. Consider the following steps in this regard. 1. 2. Sum of the odd ordinates = 22 + 36 + 1 = 89 3. Sum of the even ordinates = 15 + 29 + 38 + 22 = 104 4. 12 + 17 = 39 5. Area = 100 (19.5 + 89 + 104) 6. Area = (39 + 2 x 89 + 4 x 104) 7. Area 100 x 19.5 (104 - 89) The area of the plot can be determined by using the steps listed above :....
MCQ->The type of font axle in which the king pin is usually fixed in the stub axle forging and ends turn in the forked end of the axle beam is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution