Question Set

1. What is the distance through which the tongue rail moves laterally at the toe of the switch for movement of trains called ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....
QA->The spatial frequency of a wave, either in cycles per unit distance or radians per unit distance is called?....
QA->To toe the line....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
MCQ->What is the distance through which the tongue rail moves laterally at the toe of the switch for movement of trains called ?....
MCQ->Consider the following locations of a turnout: 1. Tongue rail 2. Lead rail 3. Toe of switch 4. Crossing. Which is the correct sequence for a train to pass over the turnout from the facing direction?....
MCQ->Radha moves towards South-East a distance of 7 km, then she moves towards West and travels a distance of 14 km. From here she moves towards North-West a distance of 7 km and finally she moves a distance of 4 km towards east. How far is she now from the starting point?....
MCQ->DIRECTIONS (Question No 43 44) Answer the following questions on the basis of the information given below. i. Trains A and B are travelling on the same route heading towards the same destination. Train B has already covered a distance of 220km before the train A started. ii. The two trains meet each other after 11 hours after start of train A Downloaded from iii. Had the trains been travelling towards each other (from a distance of 220 km) they would have met after one hour. What is the speed of trains 'B' in kmph:....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution