Question Set

1. Which of the following types of pumps can be used for concreting ? 1. Piston operated. 2. Pneumatically operated. 3. Centrifugal operated, with straight blades. 4. Screw type.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is....
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is:....
QA->On planet Earth; where is no centrifugal force?....
QA->On planet Earth, where is no centrifugal force?....
MCQ->Which of the following types of pumps can be used for concreting ? 1. Piston operated. 2. Pneumatically operated. 3. Centrifugal operated, with straight blades. 4. Screw type.....
MCQ->Consider the following statements : 1. Pumps in series operation allow the head to increase. 2. Pumps in series operation increase the flow rate. 3. Pumps ill parallel operation increase the flow rate. 4. Pumps in parallel operation allow the head to increase. Which of these statements are correct ?....
MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....
MCQ->During a gust of wind, the blades of the windmill are given an angular acceleration of = (0.2 ) rad/s2, where is measured in radians. If initially the blades have an angular velocity of 5 rad/s, determine the speed of point P located at the tip of one of the blades just after the blade has turned two revolutions.....
MCQ->Statements: Some blades are hammers. Some hammers are knives. Some knives are axes. Conclusions: Some axes are hammers. Some knives are blades. Some axes are blades.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution