Question Set

1. A symmetrical channel section is made of a material which is equally strong in tension and compression. It is used as a simply supported beam with its web horizontal to carry vertical loads. It will





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->___ are non-printing guides pulled down and across from the horizontal and vertical rulers.....
QA->.....is an instrument for measuring horizontal and vertical angles.?....
QA->_____ is the point on the ruler where the horizontal and vertical rulers intersect.....
QA->Which of the following identifies a specific web page and its computer on the web?....
QA->Which of the following identifies a specific web page and its computer on the Web ?....
MCQ->A symmetrical channel section is made of a material which is equally strong in tension and compression. It is used as a simply supported beam with its web horizontal to carry vertical loads. It will....
MCQ->The following quantities refer to a channel section used as a beam : b = width of flange (upto centre of web thickness). h = depth of web (c/c of flange thickness). t = thickness of flange and web. I = moment of inertia of channel about xx axis. e = distance of shear centre, outside the channel from the mid thickness of the web. The value of 'e' is given by....
MCQ->A fixed beam and a simply supported beam having same span and develop same maximum bending moment due to uniformly distributed load on entire span. What is the ratio of uniformly distributed load on fixed beam to that on simply supported beam ?....
MCQ->A reinforced concrete cantilever beam is 3.6 m long, 25 cm wide and has its lever arm 40 cm. It carries a load of 1200 kg at its free end and vertical stirrups can carry 1800 kg. Assuming concrete to carry one-third of the diagonal tension and ignoring the weight of the beam, the number of shear stirrups required, is....
MCQ->Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution