Question Set

1. A concentrated load acting on the surface of a soil produces a stress of 19.1 kPa at a depth of 1 m below it. Using Boussinesq's expression, the stress at 2 m depth is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Method of cultivating plants without using soil but by using nutrient solution?....
QA->When a force acting on a body produces displacement, it is called?....
QA->The device used to measure the depth of oceans using sound waves?....
QA->What is the Molten rock below the surface of the earth?....
QA->The process in which a liquid changes into its vapour from its surface at a temperature below its boiling point is called?....
MCQ->A concentrated load acting on the surface of a soil produces a stress of 19.1 kPa at a depth of 1 m below it. Using Boussinesq's expression, the stress at 2 m depth is....
MCQ->A normally consolidated clay layer settles by 25 mm when the effective stress is increased from 15 kPa to 30 kPa. If the effective stress is later increased further from 30 kPa to 60 kPa, then the additional settlement would be....
MCQ->Consider the following statements- with reference to a continuous beam supported at A, C and E for which the shear force diagram is shown in the given figure.There is 1. a concentrated load acting at point B 2. a concentrated load acting at point D 3. a uniformly distributed load acting on the portion CE. Of these statements: ....
MCQ->For water at 300°C, it has a vapour pressure 8592.7 kPa and fugacity 6738.9 kPa Under these conditions, one mole of water in liquid phase has a volume of 25.28 cm3 and that in vapour phase in 391.1 cm3.Fugacity of water (in kPa) at 9000 kPa will be....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution