1. A wooden plank (sp. gr. 0.5) 1 m x 1 m x 0.5 m floats in water with 1.5 kN load on it with 1 m x 1 m surface horizontal. The depth of plank lying below water surface shall be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->An iron needle slowly placed on the surface of water floats on it because?....
QA->‘We shall either free India or die in the attempt; We shall not live to see the perpetuation of our slavery’ Mahathma Gandhi said these words in connection with?....
QA->“The state shall have no religion of its own and all persons shall be equally entilted to freedom of conscience and right freely to profess, practice and propagate religion”- This principle is termed?....
QA->Which article of the Indian Constitution says, "No child below the age of fourteen years shall be employed to work in any factory or mine or engaged in any other hazardous employment" ?....
QA->Five equal forces of 10 N each are applied at one point and all are lying in one plane. If angles between them are equal, the resultant of these forces wil be?....
MCQ->A wooden plank (sp. gr. 0.5) 1 m x 1 m x 0.5 m floats in water with 1.5 kN load on it with 1 m x 1 m surface horizontal. The depth of plank lying below water surface shall be....
MCQ->The boy at D has a mass of 50 kg, a center of mass at G, and stands on a plank at the position shown. The plank is pin-supported at A and rests on a post at B. Neglecting the weight of the plank and post, determine the magnitude of force P his friend (?) at E must exert in order to pull out the post. Take B = 0.3 and C = 0.8.....
MCQ->A rectangular surface 3' x 4', has the lower 3 edge horizontal and 6' below a free oil surface (sp. gr. 0.8). The surface inclination is 300 with the horizontal. The force on one side of the surface is(where, y = specific weight of water)....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution