Question Set

1. The ratio of design discharge to the surface area of a sedimentation tank is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The ratio between the radius of the base and the height of a cylinder is 2 : If its volume is 1617 cm3, the total surface area of the cylinder is—....
QA->To raise a pattern or design on the surface of something.....
QA->The pressure at the bottom of a liquid tank does not depend on which area?....
QA->In a mixture of 35 litres, the ratio of milk and water is 5 : Another 5 litres of milk is added to the mixture. The ratio of milk and water in the new mixture is—....
MCQ->The ratio of design discharge to the surface area of a sedimentation tank is called....
MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)....
MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The discharge per unit plan area of a sedimentation tank, is generally called....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution