Question Set

1. A river is said to be of uniform section if in its section






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The incapability of a body to change by itself its state of rest or its state of uniform motion along a straight line?....
QA->“Christianity wins its prosperity by cutting throats of its fellow men”-Who said this?....
QA->Who said "Well done is better than well said”?....
QA->Which is the planet its length of its day and the tilt of its axis are almost identical to those of the earth?....
QA->The process in which a liquid changes into its vapour from its surface at a temperature below its boiling point is called?....
MCQ->A river is said to be of uniform section if in its section....
MCQ->A short bar element of uniform cross-section is subjected to concentrated axial forces at its two ends. The longitudinal stress distribution on the cross-section is uniform at....
MCQ->Statement: Drinking water supply to New Bombay has been suspended till further orders from Maharashtra Pollution Control Board following pollution of Patalganga river, caused by discharge of effluents from some chemical industries. Courses of Action: The industries responsible for discharging effluents into the river should be asked to close down immediately. The river water should immediately be treated chemically before resuming supply. The Pollution Control Board should check the nature of effluents being discharged into the river by industries at regular intervals.

....
MCQ->Comprehension : The Yellow River is the second largest river in China - over 3000 miles long. It rises in the mountains of Tibet and flows right across China to the east coast. The Yellow River or Hwang Ho. flows into the Yellow Sea. or Hwang Hal. The Yellow River flows into....
MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution