Question Set

1. Velocity of flow of water in plain sedimentation water tank, is normally kept






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->A​ ​light​ ​wave​ ​is​ ​incident​ ​over​ ​a​ ​plane​ ​surface​ ​with​ ​velocity​ ​X.After reflection​ ​the​ velocity​ ​becomes:....
QA->Why is a water tank appears shallower when it is viewed from top?....
QA->Which plain formed due to the weathering of lime stone?....
MCQ->Velocity of flow of water in plain sedimentation water tank, is normally kept....
MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ....
MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
MCQ->The following statements relate to a laminar flow : 1. Laminar flow is rotational. 2. In laminar flow the loss of head is proportional to the square of the velocity. 3. In laminar flow the loss of head is proportional to the first power of viscosity. 4. In laminar flow the velocity is constant over the cross-section. 5. Other quantities remaining the same, increase in diameter will increase the Reynolds number in laminar flow. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution