Question Set

1. The signal to noise ratio for a voice grade line is 30.1 dB (decibels) or a power ratio of 1023:1. The maximum achievable data rate on this line whose spectrum ranges from 300 Hz to 4300 Hz is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->Electro magnetic spectrum between 30MHzand 300 MHz is called?....
QA->Which is the highest grade of coal whose surface is shining and has the highest calorific value?....
QA->The highest singing voice in women or boys or A music in highest voice....
MCQ->The signal to noise ratio for a voice grade line is 30.1 dB (decibels) or a power ratio of 1023:1. The maximum achievable data rate on this line whose spectrum ranges from 300 Hz to 4300 Hz is....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is....
MCQ->Consider the following statements as regards noise If Gaussian noise is applied at input of a rectifier, the output is not gaussianThe noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not GaussianShot noise results from random emission of electrons from a cathodeShot noise results from phenomenon associated with the flow of current across semi conductor junctions Which of the above are correct?....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution