Question Set

1. The scale between the type guide and the cylinder is known as:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Centre Guide or type guide shows the:....
QA->The ratio between the radius of the base and the height of a cylinder is 2 : If its volume is 1617 cm3, the total surface area of the cylinder is—....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The space between the piston and cylinder is called:....
QA->The temperature which is equal in Fahrenheat Scale and Kelvin Scale?....
MCQ->Consider the following statements Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.For a given value of TM10 cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.Ridge wave guide has higher conductor losser than a rectangular waveguide.Ridge guide has higher conductor losser than a rectangular waveguide. Which of the above statements are correct?....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->The scale between the type guide and the cylinder is known as:....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->Consider the following statement (s) related to the scale of map. I. The larger the scale of the map, the larger the area it covers. II. The larger the scale of the map, the more generalized are the data it portrays. III. The smaller the scale of the map, the larger the area it covers. IV. The smaller the scale of the map, the more accurately can its content be displayed. Which of the following statement (s) is correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution