Question Set

1. In a counter-ramp A/D converter, the end-of-conversion line must be tied back to the clear input of the counter to change the circuit to perform continuous conversions.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Which organization handed over to the Army the design of Mobile Metallic Ramp (MMR) for strategic mobility of armoured and mechanised units as well as formations of the Army?....
QA->Which bank has tied up with BCG (India) on November 29, 2017, for its transformation initiatives?....
QA->To which Bill the President must accord his sanction without sending it back for fresh consideration?....
MCQ->In a counter-ramp A/D converter, the end-of-conversion line must be tied back to the clear input of the counter to change the circuit to perform continuous conversions.....
MCQ->Which of the following statements are correct? The conditional operator (?:) returns one of two values depending on the value of a Boolean expression. The as operator in C#.NET is used to perform conversions between compatible reference types. The & operator is also used to declare pointer types and to dereference pointers. The -> operator combines pointer dereferencing and member access. In addition to being used to specify the order of operations in an expression, brackets [ ] are used to specify casts or type conversions.....
MCQ->A stunt driver in car A travels in free flight off the edge of a ramp at C. At the point of maximum height he strikes car B. If the direct collision is perfectly plastic (e = 0), determine the required ramp speed vC at the end of the ramp C, and the approximate distance s where both cars strike the ground. Each car has a mass of 3.5 Mg. Neglect the size of the cars in the calculation.....
MCQ->A 4-bit stairstep-ramp A/D converter has a clock frequency of 100 kHz and a maximum input of 10 V, and has 6 V applied to the input. The conversion time will be ________.....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution