If the output of a three-input AND gate must be a logic LOW, what must the condition of the inputs be? ?->(Show Answer!)

Question Set

1. If the output of a three-input AND gate must be a logic LOW, what must the condition of the inputs be?

Show Similar Question And Answers

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

QA->Arithmetic and Logic Unit ന്റെ ധർമം എന്ത്? ....

QA->The function of Arithmetic and Logic Unit (ALU) is?....

QA->The average of six numbers is x and the average of three of these is y. If the average of the remaining three is z, then....

QA->The economic condition in which the rate at which the general level of prices for goods and services is rising and subsequently; purchasing power is falling is called?....

MCQ->Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

MCQ->If the output of a three-input AND gate must be a logic LOW, what must the condition of the inputs be?....

MCQ->The RAM circuit given below is suspected of being bad. A check with a logic probe shows pulse activity on all of the address lines and data inputs. The / line and inputs are forced HIGH and the data output lines are checked with the logic probe. Q0, Q2, and Q3 show a dim indication on the logic probe; Q1 indicates a HIGH level on the logic probe. What, if anything, is wrong with the circuit?

MCQ->Refer to the display multiplexer given below. The MSD display is blank, while the LSD seems to be OK. The input and output lines to the 74157 and 7449 are checked with a scope and can be seen changing levels. The A input on the 74139 also changes; however, the 0 output on the 74139 is always LOW and the 1 output is always HIGH. The B and EN inputs on the 74139 are always LOW. What could cause the problem and what should be done to correct it?

MCQ->An AND gate has four inputs. One of the inputs is low and other inputs are high. The output....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution