Question Set

1. A multivibrator is a circuit that changes between two digital levels on a continuous, free-running basis or on demand.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The electronic circuit which works only on two voltage levels (0 and 1) is called?....
QA->Voltage levels in a circuit is either represented by?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->The sum of squares of two numbers is 80 and the square of difference between the two numbers is Find the product of two numbers.....
MCQ->A multivibrator is a circuit that changes between two digital levels on a continuous, free-running basis or on demand.....
MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....
MCQ->Statement: The integrated steel plants in India would no longer have to depend on imports for continuous casting refractories. Assumptions: Continuous casting refractories are needed by India. Continuous casting refractories are in demand.

....
MCQ->Match the following: List I List II A.Continuous and aperiodic1.Fourier representation is continuous and aperiodicB.Continuous and Periodic2.Fourier representation is discrete and aperiodicC.Discrete and aperiodic3.Fourier representation is continuous and periodicD.Discrete and periodic4.Fourier representation is discrete and periodic

....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution