Question Set

1. For a silicon transistor, when a base-emitter junction is forward-biased, it has a nominal voltage drop of





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->On a clean glass plate a drop of water spreads to form a thin layer whereas a drop of mercury remains almost spherical because?....
QA->The default lines to drop for Drop cap is ______....
QA->The default lines to drop for drop cap is:....
QA->To be biased against....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the....
MCQ->For a silicon transistor, when a base-emitter junction is forward-biased, it has a nominal voltage drop of....
MCQ->Assertion (A): A BJT can be used as a switch. Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

....
MCQ->In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution