In a collector feedback bias circuit, the current through the collector resistor is ________ and the collector current is ________. ?->(Show Answer!)

Question Set

1. In a collector feedback bias circuit, the current through the collector resistor is and the collector current is .

Show Similar Question And Answers

QA->At the time of short-circuit; what will be the current in the circuit?....

QA->At the time of short-circuit, what will be the current in the circuit?....

QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....

QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....

QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....

MCQ->In a collector feedback bias circuit, the current through the collector resistor is ________ and the collector current is ________.....

MCQ->Assertion (A): A fixed bias BJT circuit exhibits better performance as compared to a self bias BJT circuit.Reason (R): A fixed bias BJT circuit used less components as compared to a self bias BJT circuit.

MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....

MCQ->Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistorsReason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution