Question Set

1. Digital MOSFET switches are used in the sample-and-hold circuit of an analog-to-digital converter.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The …………………..converts digital signals to analog signals for the purpose of transmitting data over telephone lines.....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Catalytic converter in modern automobiles is used for?....
MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....
MCQ->Digital MOSFET switches are used in the sample-and-hold circuit of an analog-to-digital converter.....
MCQ->Consider the following statements : Non-probability sample includes convenience sample Non-probability sample includes judgment sample Non-probability sample includes quota sample Non-probability sample includes cluster sample. Of the statements :....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->Which of the following statements are correct about the C#.NET code snippet given below? sample c; c = new sample(); It will create an object called sample. It will create a nameless object of the type sample. It will create an object of the type sample on the stack. It will create a reference c on the stack and an object of the type sample on the heap. It will create an object of the type sample either on the heap or on the stack depending on the size of the object.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution