Which of the transistors of an SCR are conducting when the SCR is fired and is in the conduction mode? ?->(Show Answer!)

Question Set

1. Which of the transistors of an SCR are conducting when the SCR is fired and is in the conduction mode?

Show Similar Question And Answers

QA->The longest electrified railway tunnel situated between Cherlopalli and Rapuru Railway stations, and measuring 6.6 kilometres has been commissioned by South Central Railway (SCR) in which state?....

QA->The temperature most suited for conducting an industrial process involving a reversible reactions; most conveniently and profitably is called?....

QA->Which surface to air missile was successfully test fired from Interim Test Range (ITR), Chandipur, Odhisa by Defence Research and Development Organisation (DRDO)?....

QA->The circuits that act as transistors, diodes, resistors etc is called?....

QA->The two elements that are frequently used for making transistors are?....

MCQ->Which of the transistors of an SCR are conducting when the SCR is fired and is in the conduction mode?....

MCQ->Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V. Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

MCQ->Consider the following statements about 8085 The instruction LDA uses direct addressing mode.The instruction MVI uses direct addressing mode.The instruction MVI uses immediate addressing mode.The instruction LDA uses immediate addressing mode. Which of the above are correct?....

MCQ->Which three statements are true about the operation of a full-duplex Ethernet network? There are no collisions in full-duplex mode. A dedicated switch port is required for each full-duplex node. Ethernet hub ports are preconfigured for full-duplex mode. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting. The host network card and the switch port must be capable of operating in full-duplex mode.....

MCQ->Assertion (A): In TE10 mode the cutoff frequency of rectangular waveguide is where a is the broad dimension and c is velocity of light.Reason (R): TE10 mode is the dominant mode in rectangular waveguide.

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution