Question Set

1. At –65ºC the minimum current that will trigger the series of an SCR is ________, while at +150ºC only ________ is required.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->At –65ºC the minimum current that will trigger the series of an SCR is ________, while at +150ºC only ________ is required.....
MCQ->A silicon power transistor is operated with a heat sink ( SA = 1.5ºC/W). The transistor, rated at 150 W (25ºC), has JC = 0.5º C/W, and the mounting insulation has CS = 0.6 ºC/W. What is the maximum power that can be dissipated if the ambient temperature is 50ºC and TJmax = 200 ºC?....
MCQ->It is suspected that the comparator in the figure given below has a problem. The inputs are activated in the table shown below and the corresponding outputs noted. What is most likely wrong with the circuit? For P0 – P3 = 1 and Q0 – Q3 = 0, P > Q = 1, P = Q = 1, P < Q = 0 For P0 – P3 = 0 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 1 For P0 – P3 = 1 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 0

....
MCQ->Determine what maximum dissipation will be allowed for a 70-W silicon transistor (rated at 25ºC) if derating is required above 25ºC by a derating factor of 0.6 W/ºC at a case temperature of 100º.....
MCQ->Solve the following equation for x, y, and z:x – y + z = –1   –x + y + z = –1   x + 2y – 2z = 5....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution