The amount of gate voltage needed to turn the JFET completely off is called VGS(OFF). ?->(Show Answer!)

Question Set

1. The amount of gate voltage needed to turn the JFET completely off is called VGS(OFF).

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....

QA->The device used for converting current from a lower voltage to a higher voltage is known as?....

QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....

QA->കമ്പ്യൂട്ടർ Turn off ചെയ്താലും ഇൻഫർമേഷൻ നഷ്ടമാവാത്ത മെമ്മറി ?....

QA->Whenever a body is immerced partially or completely in a fluid, it experiences an upward force. This is called,?....

MCQ->The amount of gate voltage needed to turn the JFET completely off is called VGS(OFF).....

MCQ->Assertion (A): A JFET behaves as a resistor when VGS < VP. Reason (R): When VGS < VP, the drain current in a JFET is almost constant.

....

MCQ->A n-channel JFET has IDSS = 2 mA, Gate to source voltage VGS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .....

MCQ->A JFET data sheet specifies VGS(off) = –6 V and IDSS = 8 mA. Find the value of ID when VGS = –3 V.....

MCQ->A JFET data sheet specifies VGS(off) = –10 V and IDSS = 8 mA. Find the value of ID when VGS = –3 V.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution