Question Set

1. The gain of an OTA is the ratio of the output current to the input voltage, and is measured in _____________.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->The output quality of printer is measured by..........
MCQ->The gain of an OTA is the ratio of the output current to the input voltage, and is measured in _____________.....
MCQ->Match the following: List I (BJT amplifier) List II (Characteristics) A.CE1.good voltage gain, good current gainB.CC2.voltage gain less than 1, high current gainC.CB3.current gain less than 1, voltage gain high

....
MCQ->Match List-I with List-II and select the right answer using the code given below: List-I List-II (Current) (Feature) A. Kuroshio current 1. Warm current in Atlantic Ocean B. Peru 2. Cold current in the current Atlantic Ocean C. Labrador 3. Warm current in the current Pacific Ocean D. Florida current 4. Cold current in the Pacific Ocean Codes: A B C D?....
MCQ->If an operational transconductance amplifier (OTA) is used as an amplitude modulator, the voltage gain is varied by applying a _________ voltage to the ______ input.....
MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution