Question Set

1. The capacity of a battery cell is measured by the amount of __________ that can be supplied over time.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->P,Q and R together earn Rs.1620 in 9 days. P and R can earn Rs.600 in 5 days. Q and R in 7 days can earn Rs. How much amount does R can earn per day?....
QA->P takes twice as much time as Q or thrice as much time as R to finish a piece of work. They can finish the work in 2 days if work together. How much time will Q take to do the work alone?....
QA->Very small time intervals can be accurately measured by?....
QA->The amount of pollution in water is measured by ?....
MCQ->The capacity of a battery cell is measured by the amount of __________ that can be supplied over time.....
MCQ->Battery X lasts longer than Battery Y. Battery Y doesn't last as long as Battery Z. Battery Z lasts longer than Battery X. If the first two statements are true, the third statement is....
MCQ->A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk time? ....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution