Question Set

1. From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->With which can Radio wave of constant amplitude be generated?....
QA->.If A=B/2,B=C(Square)/2 and C=2 Square root of 3 which is A of the following?....
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->Which one of the following is an output device?....
QA->“One caste, One religion and One God for man of the same blood and form, there is no difference animals of the same caste alone procreate Viewed thus all humanity belong to one caste”- In which book of Sree Narayana Guru these words can be seen?....
MCQ->From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier....
MCQ->Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)....
MCQ->Which of the following measurements can be done using a counter? Pulse durationInterval between two pulses Amplitude of the pulse Rise time of a pulse Select the correct answer from the codes given below:....
MCQ->If RT, Rh represent condition for reciprocity in case of transmission parameter and hybrid parameter respectively and similarly ST, Sh represent condition for symmetry in case of transmission parameter and hybrid parameter respectively then match the following : (1) RT (a) A = D (2) Rh (b) h12 = h21 (3) ST (c) AD - BC = 1 (4) Sh (d) h12 = - h21 (e) B = c (f) Δh = 1....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution