Question Set

1. Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....
QA->If the product of two numbers is 120 and the sum of their square is 289, then the sum of the two numbers is....
QA->A sum of money at simple interest amounts to Rs.815 in 3 years and to Rs. 854 in 4 years. The sum is....
QA->The simple interest on a certain amount at 4% p.a. for 4 years is Rs. 80 more than the interest on the same sum for 3 years at 5% p.a. The sum is—....
MCQ->Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time)....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution