1. Assertion (A): The propagation delay in ECL is minimum Reason (R): Transistors used in ECL switch between active and cutoff regions.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.46 am
    Since saturation is avoided switching speed is high.
Show Similar Question And Answers
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->The two elements that are frequently used for making transistors are?....
QA->Pick out the phrasal verb which means the word underlined :The officer promised to examine my ear without delay....
QA->After the pact between Gandhiji and Lord Irwin in March 1931 many leaders became critical of Gandhiji’s leadership. What was the main reason?....
QA->The minimum mass of a radio active substance required to sustain chain reaction is called its?....
MCQ->Assertion (A): The propagation delay in ECL is minimum Reason (R): Transistors used in ECL switch between active and cutoff regions.

....
MCQ->Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Assertion (A): ECL gate has very high speed of operation.Reason (R): Transistors in ECL do not go into saturation region.

....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution