The output Y of the circuit shown in the figure is ?->(Show Answer!)

Question Set

1. The output Y of the circuit shown in the figure is

Show Similar Question And Answers

QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....

QA->If the central portion of a convex lens is wrapped in black paper as shown in the figure?....

QA->At the time of short-circuit; what will be the current in the circuit?....

QA->At the time of short-circuit, what will be the current in the circuit?....

QA->The output quality of printer is measured by..........

MCQ->Refer to the given figures (a) and (b). A logic analyzer is used to check the circuit in figure (a) and displays the waveforms shown in figure (b). The actual analyzer display shows all four data outputs, Q0-Q3. The analyzer's cursor is placed at position X and all four of the data output lines show a LOW level output. What is wrong, if anything, with the circuit?

MCQ->For the circuit shown in the figure, the capacitor C is initially uncharged. At t = 0, the switch S is closed. The voltage Vc across the capacitor at t = 1 millisecond is (In the figure shown above, the op-amp is supplied with ± 15 V and the ground has been shown by the symbol) ....

MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....

MCQ->The BCD/DEC decoder shown in figure (a) is examined with a logic analyzer and the results are shown in the waveforms in figure (b). What, if anything, is wrong with the circuit?

MCQ->The current wave shape shown in figure (1) is applied to a circuit element. The voltage across the element is shown in figure (2). The element is ....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution