Question Set

1. Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->As per the revised Goods and Services Tax (GST) norms, the GST on Haj and Kailash Mansarovar Yatra has been reduced from 18 per cent to how much per cent?....
QA->Lines per inch (lpi) is related to....
QA->Access method is used for obtaining a record from a cassette tape is _____.....
QA->Distance between two stations A and B is 778 km. A train covers the journey from A to B at 84 km per hour and returns back to A with a uniform speed of 56km per hour. Find the average speed of the train during the whole journey?....
QA->The length and breadth of a rectangular field in the ratio of 12: 7 . Find the length if area of the field is 52,500 Sq.m?....
MCQ->Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is....
MCQ->What is the byte capacity of a drum which is 5 inch high, 10 inch diameter, and which has 60 tracks per inch and bit density of 800 bits per inch?....
MCQ->Read the following statements Magnetic tape is a sequential device.Magnetic disc is a direct access device.Magnetic tape and disc are both sequential devices.Magnetic tape and disc are both direct access devices. Which of the above statements are correct?....
MCQ->Which among the following was the main objectives of “Command Area Development Programme”?1.%%To improve the utilization of the created irrigation potential 2.%%To fill the gap created between potential creation and utilization 3.%%To launch smaller irrigation schemes in India aggressively.?....
MCQ->The following steps are necessary to obtain sufficient accuracy with the tape : 1. Keeping uniform tension on tape for each measurement: 2. "Breaking" tape on slopes are necessary to keep the tape level. 3. Keeping accurate count of the stations. 4. Keeping the tape on the line being measured. The correct sequence of these steps is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution