Question Set

1. The simplest standing wave is due to the value of reflection co-efficient is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A​ ​light​ ​wave​ ​is​ ​incident​ ​over​ ​a​ ​plane​ ​surface​ ​with​ ​velocity​ ​X.After reflection​ ​the​ velocity​ ​becomes:....
QA->In a standing wave the distance between a node and adjacent antinode is______.?....
QA->Mirage is observed in a desert due to the phenomenon of which reflection?....
QA->The reflection of a ray from a straight path due to particles, or in the interface between two media is called?....
QA->Echo and reverberation are due to the reflection of?....
MCQ->The simplest standing wave is due to the value of reflection co-efficient is....
MCQ->Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-lengthReason (R): When line is terminated in resistance RL, the standing wave ratio is SWR = Z0/RL or RL/Z0

....
MCQ->Assertion (A): Two equal and opposite travelling waves result in a standing wave.Reason (R): The ratio of maximum to minimum value of a standing wave is called SWR.

....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figure. Reflection coefficient is given by....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution