Question Set

1. A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE10 mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->The length of a rectangular floor is 2 meters more than its width and its perimeter is 20 meters, then its area is....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->Movement of cell against concentration gradient is called?....
QA->Which port has become the first Indian port operator to achieve a new record of handling 200 million tonnes (MT) cargo movement?....
MCQ->A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE10 mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be....
MCQ->Assertion (A): In TE10 mode the cutoff frequency of rectangular waveguide is where a is the broad dimension and c is velocity of light.Reason (R): TE10 mode is the dominant mode in rectangular waveguide.

....
MCQ->A rectangular waveguide having TE10 mode as dominant mode is having a cut off frequency of 18 GHz for the TE30 mode. The inner broad wall dimension of the rectangular waveguide is....
MCQ->Consider the following statements: For a square waveguide of cross-section 3m x 3m it has been found At 6 GHz dominant mode will propagateAt 4 GHz only dominant modes and evanescentAt 11 GHz all the modes and no higher order mode will propagateAt 7 GHz degenerate modes will propagate Which of the above statements are correct?....
MCQ->Consider the following statements relating to hydraulic gradient line and energy gradient line 1. In the case of a fluid flowing in a pipeline, hydraulic gradient line and energy gradient line may coincide. 2. The line joining the points representing piezometric heads is known as hydraulic gradient line. 3. In the case of ideal fluid, energy gradient line is always horizontal. 4. Hydraulic gradient line has a downward slope in the case of flow through pipes. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution