1. In a medium if ε, μ and σ are constant throughout the medium, then it is known as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Arjun walks 20 m towards North. Then he turns right and walks 30 ms. Again he turns right and walks 35 ms. Then he turns left and walk 15 ms. How far and in which direction Arjun now from his starting point?....
QA->For a body moving with constant speed in a horizontal circle; what remains constant?....
MCQ->For transmission of waveform a dielectric medium of permittivity ε1 into a dielectric medium of lower permittivity ε2 , (ε1 > ε2) the critical angle of incidence θc (relative to the interface) is given by....
MCQ->In a medium if ε, μ and σ are constant throughout the medium, then it is known as....
MCQ->When a plane wave is incident normally from dielectric '1' (μ0, ε1) onto dielectric '2' (μ0, ε2) the electric field of the transmitted wave is 2 times the electric field of the reflected wave. The ratio ε2/ε1 is....
MCQ->Distilled water at 25°C is characterized by σ = 1.7 x 10-4 mho/m and ε = 78 ε0 at a frequency of 3 GHz. Its loss tangent is (ε = 10-9/36p F/m)....
MCQ->The rectangular block shown in the given figure is subjected to pure shear to intensity 'q'. If BE represents the i principal plane and the principal stresses are σ1, σ2 ; then the values of θ, σ1 and σ2 will be respectively. ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution