In a bipolar junction transistor a dc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is ?->(Show Answer!)

Question Set

1. In a bipolar junction transistor a dc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is

Show Similar Question And Answers

QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....

QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....

QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....

QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....

QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....

MCQ->When troubleshooting a bipolar junction transistor using an ohmmeter, if one of the junctions reads low in both directions, the junction is shorted and the transistor is bad. If one of the junctions reads high in both directions, the junction is shorted and the transistor is good.....

MCQ->In a bipolar junction transistor a dc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is....

MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....

MCQ->Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistorsReason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

MCQ->In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution